Reversive plow of PR(PO)-3/4/5
Now we bring to your attention reversive plows like PR(PО) of three, four and five case, for an agregatirovaniye with tractors of a class of draft of a 1,4-3tona which meet the last requirements of the market and are supplied with all types of adjustments:
- The provision of a frame of a plow concerning the soil.
- Width of capture of the case and plow.
- Angle of attack of cases.
- Processing depth.
- Horizontal adjustment of a frame for withdrawal elimination.
Which in total made possible adaptation of a plow for any working conditions and to provide the most economy mode robots.
1. Adjusting screws 1 in drawing it is possible to adjust the provision of a frame of a plow takimobrazy; that it was parallel to the platform.
2. Installation of the required width of capture of cases is made in the following order:
3. Regulation of an angle of attack is carried out by means of adjusting screws 2 after a nekotorogooslableniye of case screws 1. If the plow badly enters the soil, improvement of deepening can be provided by increase in an angle of attack by means of adjusting screws 2.
4. The required depth of a plowed land is established by adjustment of a basic wheel and drafts of hinged system of a tractor.
5. Installation of the line of draft a tractor - a plow is made by means of the adjusting screw 6 in fig. so that lateral draft was completely eliminated. The tractor takes away towards the plowed field - to truncate the adjusting screw 6. The tractor takes away towards the fallow field - to extend the adjusting screw 6.
1. During the work with a reversive plow, in comparison with a simple plow, fuel consumption is cut, productivity increases, plowing turns out more qualitative, and the term of operation increases.
2. A possibility of operation in all climatic zones;
3. Wide range of settings:
plow frame position on the soil relation;
width of capture of the case and plow;
case angle of attack;
depth of processing of the soil;
horizontal control of a frame, for elimination of lateral draft.
4. The special design of a mill from two main parts, increases knife operating time;
5. The self-sharpened working bodies;
6. Height of a rack is 600 mm (+100 mm);
7. The rack fastens to a frame, through srezny a bolt.